Motorola MVME2300 Series 用户手册
2-1
2
2
Raven PCI Bridge ASIC
Introduction
This chapter describes the architecture and usage of the Raven ASIC, a
PowerPC-to-PCI-Local-Bus bridge controller chip. The Raven is intended
to provide PowerPC 60x (MPC60x) compliant devices access to devices
residing on the PCI Local Bus. In the remainder of this chapter, the
MPC60x bus is referred to as the "MPC bus" and the PCI Local Bus is
referred to as "PCI". PCI is a high-performance 32-bit or 64-bit, burst
mode, synchronous bus capable of transfer rates of 132 MB/sec in 32-bit
mode or 264 MB/sec in 64-bit mode using a 33MHz clock.
PowerPC-to-PCI-Local-Bus bridge controller chip. The Raven is intended
to provide PowerPC 60x (MPC60x) compliant devices access to devices
residing on the PCI Local Bus. In the remainder of this chapter, the
MPC60x bus is referred to as the "MPC bus" and the PCI Local Bus is
referred to as "PCI". PCI is a high-performance 32-bit or 64-bit, burst
mode, synchronous bus capable of transfer rates of 132 MB/sec in 32-bit
mode or 264 MB/sec in 64-bit mode using a 33MHz clock.
Features
The following table summarizes the characteristics of the Raven ASIC.
Table 2-1. Features of the Raven ASIC
Function
Features
MPC Bus Interface
Direct interface to MPC603 or MPC604 processors
64-bit data bus, 32-bit address bus
Four independent software-programmable slave map decoders
Multi-level write-post FIFO for writes to PCI
Support for MPC bus clock speeds up to 66MHz
Selectable big- or little-endian operation
3.3V signal levels
PCI Interface
Fully PCI Rev. 2.0 compliant
32-bit or 64-bit address/data bus
Support for accesses to all four PCI address spaces
Single-level write-posting buffers for writes to the MPC bus
Read-ahead buffer for reads from the MPC bus
Four independent software-programmable slave map decoders