Acer AcceleRAID 352 用户手册

Installation Checklist

2-4

AcceleRAID 352 Installation Guide

☛

It is recommended that you wear a grounded wrist 
strap when working with hardware installation 
procedures. 

1. ____ Power off your computer system.

2. ____ Decide which available PCI slot will be used.

3. ____ Remove the plate from the I/O access port to the PCI slot.

4. ____ Remove the AcceleRAID 352 controller from the anti-static bag. 

5. ____ Plug the AcceleRAID 352 controller into a standard PCI slot 

(PCI 2.1 or 2.2 compliant--if using hotplug feature, must be 2.2).

6. ____ Tighten the AcceleRAID 352 controller into the mounting 

bracket.

7. ____ Connect the SCSI cable(s) from your drive(s) and/or device(s) to 

the desired SCSI channel. 

8. ____ Check SCSI termination for internal and/or external devices.

9. ____ Check disk drives. Be sure termination is set to the disabled 

position on any disk drive(s) that will not be terminated. For more 
information, see the documentation that accompanied the disk 
drives.

10. ____ Set SCSI ID on the disk drive(s).

11. ____ Enable termination power on disk drive(s).

12. ____ Safety check the installation.

☛

Review Figure 2-1 and Table 2-5 to get familiar with 
the layout of the AcceleRAID 352 controller and the 
Connectors, Jumpers, and LED descriptions. 

13. ____ Go to Chapter 3, Controller Start-up.