Cisco Systems 1000 Series 用户手册

Router(config-vrf)# route-target import 10:3

Router(config-vrf)# route-target export 10:3

Router(config-vrf)# mdt default mpls MLDP 2.2.2.2

mdt default mpls MLDP root-node

Router(config-if)# end

Router(config)# ip mroute vrf red 40.0.0.0 255.255.255.0 fallback-lookup vrf blue

Router(config-if)# end

Router# enable

Router# conf t

Enter configuration commands, one per line.  End with CNTL/Z.

Router(config)# ip vrf blue1

Router(config-if)# rd 10:3

Router(config-if)# vpn id 10:3

Router(config-vrf)# route-target import 10:3

Router(config-vrf)# route-target export 10:3

Router(config-vrf)# mdt default mpls MLDP 2.2.2.2

Router(config)# ip mroute vrf red 40.0.0.0 255.255.255.0 fallback-lookup vrf blue

Router(config-if)# end

TE-FRR provides link protection, however TE-FRR on MLDP provides link protection only for the 
single hop primary path. Node protection is not supported.These are the highlights:

Backup tunnel support

Backup bandwidth protection

For more information on MPLS TE-FRR, see 

.

ip multicast mpls traffic-eng [range {access-list-number | access-list-name}]

Router> enable

Enables privileged EXEC mode. 

Enter your password when prompted.

 terminal

Router# configure terminal

Enters global configuration mode.