Lucent Technologies 6000 用户手册

11-30

MAX 6000/3000 Network Configuration Guide

Setting Up Virtual Private Networks
Configuring PPTP tunnels for dial-in clients

Line 4 tunnel type=None

Route line 4=0.0.0.0

Exit the profile and, at the exit prompt, select the exit and accept option.

The PAC must have a route to the destination address, in this case a route through the ISP POP 
#2. It does not have to be a static route. It can be learned dynamically by means of routing 
protocols. The remaining steps of this procedure configure a static route to ISP POP #2:

Open an unused IP Route profile and activate it. For example:

Ethernet

Static Rtes

Name=pop2

Active=Yes

Specify the PNS destination address:

Dest=10.65.212.11

Specify the address of the next-hop router (ISP POP #2). For example:

Gateway=10.1.2.4

Specify a metric for this route, the route’s preference, and whether the route is private. For 
example:

Metric=1

Preference=100

Private=Yes

Exit the profile and, at the exit prompt, select the exit and accept option.

You can initiate a PPTP session in which the terminal-server interface routes the session to a 
PPTP server. The PPTP command gives you two options for selecting the tunnel the MAX 
creates. You can specify either the IP address or hostname of the PPTP server. Normal PPTP 
authentication proceeds once the MAX creates the tunnel.

Enter the command at the terminal-server prompt as follows:

 pptp_server

where pptp_server

 

is the IP address or hostname of the PPTP server. When you enter the 

command, the system displays the following text:

PPTP: Starting session

PPTP Server pptp_server