Magma EB2 用户手册

     

                                                            15  

 

DO NOT TURN OFF THE MAGMA EXPANSION CHASSIS UNTIL 
YOU HAVE SHUT DOWN YOUR COMPUTER COMPLETELY!  It 
can cause a system lockup and loss of any unsaved data.   

 

 

When shutting your system down, it is recommended that you first shut 
down the computer correctly, and then power down the Magma 
expansion chassis to avoid ‘computer lock-up’ and potential data loss. 

Locate a vacant 1U slot in your rack that is within the reach of the iPass 
data cable provided with your EB2 Expansion System. Install the rails in 
the rack as shown below: 

 

Measure the rack from front to 
back so you can confirm how 
long the rail must be to fit 
properly. 

 

 

Next, assemble the Slide piece with the end bracket as shown and 
secure with 2 Panhead screws and locking nut. Ensure the Phillips 
screw head is located on the “open” side of the Slide pieces as shown. 

Tighten finger tight only to allow for minor 
adjustment during assembly. 

Depending on the depth of your rack you 
may select either the long or the short end 
bracket. 

Attach 2 Panhead screws into the rack post where you want the chassis 
mounted. Be sure you have measured accurately to ensure that 
everything fits in the rack correctly. Leave the screws untightened until 
after you place the slide rail’s fingers between the screws as shown.