Motorola 556315-005-00 用户手册

B 

9 • Wireless Pages 

74 

  

Installing Wireless Clients 

Note: Use the SBG901 Installation CD-ROM to set the client security. 
The passcode is located on the 

For each wireless client computer (station), install the wireless adapter by following the 
instructions supplied with the adapter. Be sure to: 

1.  Insert the CD-ROM for the adapter in the CD-ROM drive on the client. 

2.  Install the device software from the CD. 

3.  Insert the adapter in the PCMCIA or PCI slot or connect it to the USB port. 

4.  Configure the adapter to obtain an IP address automatically. 

You may need to do the following to use a wireless client computer to access the 
Internet: 

Configuring a Wireless Client for WPA or WPA2 

Configuring a Wireless Client for WEP 

Configuring a Wireless Client with the Network Name 
(SSID) 

No configuration on client required 

Configuring a Wireless Client for WPA 

If you enabled WPA and set a PSK Passphrase by configuring WPA on the SBG901, you 
must configure the same passphrase (key) on each wireless client. The SBG901 cannot 
authenticate a client if: 

• 

WPA is enabled on the SBG901, but not on the client 

• 

The client passphrase does not match the SBG901 PSK Passphrase