McDATA 3000 用户手册

 

To verify the current version of WebView on your UltraNet Edge 
3000, follow the procedure “Verify your Current Software Version”, 
found on page -2 in this chapter.

WebView has been tested on the following operating systems and 

browsers:

— Windows 98, NT, and 2000

— Internet Explorer 5.0, 5.5 and 6.0

Obtain the most current UltraNet WebView software release from 
McDATA Customer Support and install it on the Windows PC used 
to configure the network.

Use the following procedure to FTP the WebView software to the 
UltraNet Edge 3000 root directory.

1. Use the FTP protocol to download the software from your PC to 

the UltraNet Edge 3000. 

2. FTP the UltraNet WebView software (.rpm file) from your PC to 

the root directory of the UltraNet Edge 3000. 

The FTP client must be set for the transfer type of binary. The FTP 
client only requires a password if one was previously defined in 
the UltraNet Edge 3000.

Use the following procedure to install the new software:

1. Telnet into the UltraNet Edge 3000.

2. Enter the correct password if previously defined.

3. Issue the following command at the UltraNet Edge 3000 prompt:

tm.0x10> upgrade -w wvxx.rpm 

where: xx is the version of software you are upgrading to

example: 

tm.0x10> upgrade -w wv32.rpm

 

where: wv32 is WebView version 3.2

The software will be updated, the following is an example of the 
context that will appear:

upgrade -w wv32.rpm
cfg envput _RPMCPUCheckDisabled YES