Netopia 4752 用户手册

The following IP Profile Options screen is displayed for an IPsec Connection Profile.

■

You must specify an SPI (Security Parameters Index), which is the ESP receive side SPI and the default 
SPI for ESP transmit, AH receive, and AH transmit. It must be unique relative to any other configuration 
profile “ESP Receive SPIs.” (See 

■

You must specify a Remote Tunnel Endpoint Address. Specify the IP address of your tunnel par tner, the 
endpoint of the tunnel. The Remote Tunnel Endpoint Address may be 0.0.0.0, which implies that the IPsec 
tunnel will not be established until packets are received on the SPI specified. At that time the tunnel will be 
bound to the Remote Tunnel Endpoint until traffic from the remote gateway ceases for a timeout period.

■

You must specify a Remote Members Network address. This specifies the subnet of the remote IPsec 
tunnel and will be used with the Remote Members Mask to determine and set the route.

■

You must specify a Remote Members Mask. This is the subnet mask of the remote subnet to which the 
IPsec tunnel will route.

■

You can specify Address Translation Enabled. For more information see 

 If Address Translation Enabled is set to Yes, you can specify the following three 

fields:

■

NAT Map List

■

NAT Server List

■

PAT IP Address
(Note: Since there is no protocol to derive this address, 0.0.0.0 is not permitted.)

Map Lists, Ser ver Lists, and PAT addresses are described in detail in 

■

You can specify a Filter Set. See 

.

                             IP Profile Options

         SPI (Security Parameters Index):   123456789

         Remote Tunnel Endpoint Address:    0.0.0.0
         Remote Members Network:            0.0.0.0
         Remote Members Mask:               0.0.0.0

         Address Translation Enabled:       Yes
         NAT Map List...                    Easy-PAT List
         NAT Server List...                 Easy-Servers
         PAT IP Address:                    1.1.1.1

         Filter Set...                      <<None>>
         Remove Filter Set

         Advanced IP Profile Options...

                 COMMIT                     CANCEL