3com 3C13701 用户手册
3Com Router 5000 and Router 6000 v2.41
Module Guide
Module Guide
Chapter 3
Multifunctional Interface Modules (Router 5000)
3-25
Caution:
Before connecting an SA module, confirm the model of the equipment to be connected to the SA module
(that is, sync/async mode, DTE/DCE mode, and so on), signaling criterion required by the access
equipment, baud rate, and timing clock.
(that is, sync/async mode, DTE/DCE mode, and so on), signaling criterion required by the access
equipment, baud rate, and timing clock.
I. Connecting interface cable of Router 4-Port Serial MIM
Step 1: Plug the DB-100 connector of a Router 4-Port Serial MIM conversion cable to
the appropriate DB-100 port on the Router 4-Port Serial MIM module;
the appropriate DB-100 port on the Router 4-Port Serial MIM module;
Step 2: Select a correct sync/async serial interface cable. Connect one end of the
cable to the DB50 connector of the Router 4-Port Serial MIM conversion cable and the
other end to:
cable to the DB50 connector of the Router 4-Port Serial MIM conversion cable and the
other end to:
z
Port of CSU/DSU, if the WAN is a DDN line;
z
Serial port of analog modem, if the WAN is a dial-up line;
Step 3: Power on the Router, and check the LEDs of the corresponding slot on the
front panel: ON means that the MIM is operating normally and OFF means that the
POST of the MIM has failed. In the latter case, please contact your agent.
front panel: ON means that the MIM is operating normally and OFF means that the
POST of the MIM has failed. In the latter case, please contact your agent.
Step 4: Check the behavior of the LINK LED on the Router 4-Port Serial MIM panel. It
is OFF when the line is faulty and signal is out of synchronization.
is OFF when the line is faulty and signal is out of synchronization.
Caution:
You should connect a cable to the port with the correct mark. Misplugging is prone to impair the SIC/MIM
and even damage the router.
and even damage the router.
3.7 Router 2 AND 4-Port Enhanced Serial MIM
3.7.1 Introduction
Router 2 AND 4-Port Enhanced Serial MIM, 2-/4-port enhanced high-speed
sync/async serial interface card, transmits, receives, and processes data on the
synchronous/asynchronous serial interface. They support both synchronous and
asynchronous modes. In the former case, they support the DTE/DCE mode.
sync/async serial interface card, transmits, receives, and processes data on the
synchronous/asynchronous serial interface. They support both synchronous and
asynchronous modes. In the former case, they support the DTE/DCE mode.
I. DTE and DCE
An FIC-SA card is usually connected to an external modem for dialing purpose, where
an appropriate baud rate setting is required.
an appropriate baud rate setting is required.