Paradyne 9820-2M 用户手册
Troubleshooting
8-11
9820-A2-GB20-20
June 2000
Troubleshooting Tables
The unit is designed to provide many years of trouble-free service. However, if a
problem occurs, refer to the appropriate table in the following sections for
possible solutions.
problem occurs, refer to the appropriate table in the following sections for
possible solutions.
Device Problems
Table 8-2.
Device Problems (1 of 2)
Symptom
Possible Cause
Solutions
No power, or the LEDs
are not lit.
are not lit.
The power cord is not
securely plugged into the
wall receptacle to rear
panel connection.
securely plugged into the
wall receptacle to rear
panel connection.
Check that the power cord is
securely attached at both ends.
securely attached at both ends.
The wall receptacle has no
power.
power.
H
Check the wall receptacle
power by plugging in some
equipment that is known to be
working.
power by plugging in some
equipment that is known to be
working.
H
Check the circuit breaker.
H
Verify that your site is not on
an energy management
program.
an energy management
program.
Power-On Self-Test
fails. The Alarm LED
is on after power-on.
fails. The Alarm LED
is on after power-on.
The unit has detected an
internal hardware failure.
internal hardware failure.
H
Reset the unit and try again.
H
Contact your service
representative.
representative.
Cannot access the
FrameSaver unit or
the menu-driven user
interface.
FrameSaver unit or
the menu-driven user
interface.
Login or password is
incorrect, COM (Terminal)
port is misconfigured, or the
FrameSaver unit is
otherwise configured so it
prevents access.
incorrect, COM (Terminal)
port is misconfigured, or the
FrameSaver unit is
otherwise configured so it
prevents access.
H
Reset the FrameSaver unit
(
(
Main Menu
→
Control
→
Reset Device).
H
Contact your service
representative.
representative.