Siemens S323 用户手册
UMN:CLI User Manual
SURPASS hiD 6615 S223/S323 R1.5
274 A50010-Y3-C150-2-7619
[Sample Configuration 2] Accessing from Master Switch to Slave Switch
The following is an example of accessing to Slave switch from Master switch configured
in [Sample Configuration 1]. If you show the configuration of Slave switch in [Sample
Configuration 1], you can recognize node-number is 2.
in [Sample Configuration 1]. If you show the configuration of Slave switch in [Sample
Configuration 1], you can recognize node-number is 2.
SWITCH(bridge)# rcommand 2
Trying 127.1.0.1(23)...
Connected to 127.1.0.1.
Escape character is '^]'.
SWITCH login: admin
Password:
SWITCH#
To disconnect, input as below.
SWITCH# exit
Connection closed by foreign host.
SWITCH(bridge)#
8.11
Broadcast Storm Control
The hiD 6615 S223/S323 supports broadcast storm control for broadcast packets. Broad-
cast storm is overloading situation of broadcast packets since they need major part of
transmit capacity. Broadcast storm may be often occurred because of difference of ver-
sions. For example, when there are mixed 4.3 BSD and 4.2 BSD, or mixed AppleTalk
Phase I and Phase II in TCP/IP, Storm may occur
cast storm is overloading situation of broadcast packets since they need major part of
transmit capacity. Broadcast storm may be often occurred because of difference of ver-
sions. For example, when there are mixed 4.3 BSD and 4.2 BSD, or mixed AppleTalk
Phase I and Phase II in TCP/IP, Storm may occur
In addition, when information of routing protocol regularly transmitted from router incor-
rectly recognized by system, which does not support the protocol, Broadcast Storm may
be occurred.
rectly recognized by system, which does not support the protocol, Broadcast Storm may
be occurred.
Broadcast Storm Control is operated by system counts how many Broadcast packets are
there for a second and if there are packets over configured limit, they are discarded.
there for a second and if there are packets over configured limit, they are discarded.
The hiD 6615 S223/S323 provides not only broadcast storm but also control of multicast
and DLF (Destination Lookup Fail) storm. In order to use control of multicast and DLF
storm, use the following commands. Then all configurations of Broadcast storm control
will be equally applied to all VLANs.
and DLF (Destination Lookup Fail) storm. In order to use control of multicast and DLF
storm, use the following commands. Then all configurations of Broadcast storm control
will be equally applied to all VLANs.
To enable multicast storm control and DLF storm control, use the following command.
Command Mode
Description
storm-control
{broadcast | mul-
ticast
| dlf} RATE [PORTS]
Bridge
Enables broadcast, multicast, or DLF storm control
respectively in a port with a user defined rate. Rate
value is from 1 to 262142 for FE, and from 1 to
2097150 for GE
respectively in a port with a user defined rate. Rate
value is from 1 to 262142 for FE, and from 1 to
2097150 for GE
By default, DLF storm control is enabled and multicast storm control is disabled.
To disable multicast storm control and DLF storm control, use the following commands
i