TANDBERG D13202 用户手册
TANDBERG GW
Dataport Command Interface User Guide
D13202 Rev 01
4
2.
Connecting to the Dataport Command Interface through the
RS-232 port.
RS-232 port.
The RS-232 port is a 9-pin, female, D-sub connector located on the back of the GW. The port
is configured as a DCE (Data Communications Equipment). The RS-232 port is default set to
9600 baud, 8 databits, none parity and 1 stopbit from factory. The RS-232 port is also referred
to as the Dataport.
is configured as a DCE (Data Communications Equipment). The RS-232 port is default set to
9600 baud, 8 databits, none parity and 1 stopbit from factory. The RS-232 port is also referred
to as the Dataport.
2.1.
Hardware And Cabling
The pin outs for the RS-232 are defined in the following table (the DTE, Data Terminal
Equipment, could be a PC or other device capable of serial communication).
Equipment, could be a PC or other device capable of serial communication).
Pin no
Signal
Description
Direction
1
CD
Carrier detect
To DTE
2 RD
Receive
data
To
DTE
3 TD
Transmit
data
From
DTE
4
DTR
Data terminal ready
From DTE
5
Ground
6
DSR
Data set ready
To DTE
7
RTS
Ready to send
From DTE
8
CTS
Clear to send
To DTE
9
RI
Ring indicator
To DTE
NOTE! A straight through cable should be used between the TANDBERG GW’s RS-232 port
and the DTE.
and the DTE.
The figure below illustrates the recommended cable-wiring scheme for connecting the GW to
a PC through RS-232.
a PC through RS-232.
DTR and RTS are ignored. DSR, CD, and CTS are always asserted, while RI is not used.
TANDBERG GW
PC
DCE, 9 pin
DTE, 9 pin
1 CD
1 CD
2 RD
2 RD
3 TD
3 TD
4 DTR
4 DTR
5 GND
5 GND
6 DSR
6 DSR
7 RTS
7 RTS
8 CTS
8 CTS
9 RI
9 RI