GarrettCom DX40 用户手册
DX40 Serial Device Router Installation Guide
9
Chapter 2
Installation
This chapter provides specific procedures for installing the Magnum DX40, preparing for
installation, and uninstalling the device.
installation, and uninstalling the device.
2.1
Preparing for Installation
The DX40 is designed to be installed on a DIN rail system or on a panel.
2.1.1
Tools
Regardless of which mounting system you are using, the only tools you will need are
screwdrivers: a small slotted screwdriver for the power connector and a medium slotted
screwdriver for wall mounting and the grounding screw. (The 6-32 pan head grounding
screw will accept both phillips head and slotted screwdrivers.)
screwdrivers: a small slotted screwdriver for the power connector and a medium slotted
screwdriver for wall mounting and the grounding screw. (The 6-32 pan head grounding
screw will accept both phillips head and slotted screwdrivers.)
The instructions in this manual cover only the physical installation. System configuration
is handled through a web-based interface and is described in the Magnum Network
Software – DX Administrator’s Guide.
is handled through a web-based interface and is described in the Magnum Network
Software – DX Administrator’s Guide.
2.1.2
Site Suitability
Be sure that your installation site meets the following criteria:
•
Conforms with the temperature and humidity ranges detailed in
•
.
•
Will remain stable after the addition of the 3.5 lb. DX40.
•
Permits at least two inches of space between the DX40 and any other heat-
producing device.
producing device.