TP-LINK TD-W8950ND 用户手册

¾

  Broadband Internet Access Service (DSL/Cable/Ethernet). 

¾

  PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors. 

¾

  TCP/IP protocol on each PC. 

¾

  Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari. 

¾

  Place the modem router in a well ventilated place far from any heater or heating vent 

¾

  Avoid direct irradiation of any strong light (such as sunlight) 

¾

  Keep at least 2 inches (5 cm) of clear space around the modem router 

¾

 Operating temperature: 0℃~40℃ (32℉~104℉) 

¾

 Operating Humidity: 10% ~ 90% RH (non-condensing) 

Before installing the modem router, please make sure your broadband service provided by your 
ISP is available. If there is any problem, please contact your ISP. After that, please install the 
modem router according to the following steps. Don't forget to pull out the power plug and keep 
your hands dry.   

1.  Locate an optimum location for the modem router. The best place is usually at the center of 

your wireless network. 

2.  Adjust the direction of the antenna. Normally, upright is a good direction. 

3.  Connect your PC and Switch/Hub in your LAN to the LAN Ports of the modem router. (If you 

have a wireless NIC and want to have wireless connection, please skip this step.) 

4.  Connect the telephone line to the Line port on the modem router. Or you can access the 

Internet and make calls at the same time by using a separate splitter to divide the data and 
voice. The external splitter has three ports: 

•  LINE: Connect to the wall jack 

•  PHONE: Connect to the phone sets 

•  MODEM: Connect to the ADSL LINE port of device 

Plug one end of the twisted-pair ADSL cable into the ADSL LINE port on the rear panel of 
device. Connect the other end to the MODEM port of the external splitter. 

5.  Connect the power adapter to the power plug of the modem router, and the other end into an 

electrical outlet. The electrical outlet shall be installed near the device and shall be easily 
accessible. 

6.  Turn on the ON/OFF switch to power the device. It will start to work automatically. 

7