Atlantis Land A02-RA340 用户手册

                                                                                                                            

WebShare 340/440  

 

44 

 

checks these different filter rules one by one, stating from the first rule. As long as one of the 
rules is satisfied, the specified action will be taken. 

•  Add TCP/UDP Filter: Click this button to add a new packet filter rule. After click, next 

figure will appear. 

•  Add Raw IP Filter: Click this button to add a new Protocol Filter.  
•  Packet Filter Rules: On this table, you see packet filter rules; you can click on Edit to 

modify rule or Delete 

 

•  Rule Name: Insert rule name; rule name must be different 
•  Time Schedule: It is self-defined time period. You may specify a time schedule for 

your prioritization policy. For setup and detail, refer to Time Schedule section  

•  Source IP Address(es) / Destination IP Address(es): This is the Address-Filter 

used to allow or block traffic to/from particular IP address(es). Selecting the Subnet 
Mask of the IP address range you wish to allow/block the traffic to or form; set IP 
address and Subnet Mask to 0.0.0.0 to inactive the Address-Filter rule. 

•  Type: Specify the packet type (UDP or TCP) that the rule will be applied to. 
•  Source Port: This Port or Port Ranges defines the port allowed to be used by the 

Remote/WAN to connect to the application. Default is set from range 0 ~ 65535. It is 
recommended that this option be configured by an advanced user. 

•  Destiantion Port: This is the Port or Port Ranges that defines the application. 
•  Inbound / Outbound: Select Allow or Block the access to the Internet 

(“Outbound”) or from the Internet (“Inbound”).