Vista Imaging Vista Routing 用户手册

Routing User Guide

Appendix B: Using MAG_Decompressor 

Note: If the DLL file is not present, contact the Imaging Group for information 
about acquiring a toolkit license.  The decompression software will not work 
without the DLL file. 

d 

Enter the following command to activate the program (The command will
complete without any warning or error messages). 

Mag_Decompressor –install <Enter> 

e 

Close the command window. 

5 

Activate the decompression service as follows: 

In the Control Panel, double-click Administrative Tools. 

Double-click Services. (On some versions of the Windows operating system, this 
icon is labeled Component Services.) 

In the window that opens, locate the entry for the “MAG J2K Decompressor 
Service”. 

Right-click on the entry and select Start. Wait until the status display shows that 
the service is started. 

Right-click again on the entry and select Properties. 

In the Properties window, select Automatic as the startup type, then click OK. 

Verify that the status display shows that the service is “Automatic”. 

Close all remaining Control Panel windows. 

Your system is now ready to start decompressing files that were routed in compressed 
form. 

Note: when parameters need to be modified, the steps listed above can be used to 
establish new values for the parameters. However, it will be necessary to reboot the 
computer before the new values of the parameters will become effective. 

The decompression software will run automatically when needed.  If problems are 
encountered review, the log files generated by the MAG_Decompressor software. 

Log files are stored in the location specified in the DECOMP_LOG_FSPEC system 
variable. The ten most recently generated log files are retained. 

2005-04-19 16:59:01 ----------------------------------------------------------------------------------------------- 

April 2006

VistA Imaging V. 3.0, Patch 18 

81