ZyXEL Communications nbg-418n 用户手册
Chapter 6 Wireless LAN
NBG-418N User’s Guide
82
6.11 AP Select Screen
Use this screen to choose an access point that you want the NBG-418N (in universal repeater or
client bridge mode) to connect to. You should know the security settings of the target AP.
client bridge mode) to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN > AP Select tab.
Figure 60
Network > Wireless LAN > AP Select
The following table describes the labels in this screen.
Table 36
Network > Wireless LAN > AP Select
LABEL
DESCRIPTION
Select
Use the radio button to select the wireless device to which you want to connect.
SSID
This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
BSSID
This displays the MAC address of the wireless device.
Channel
This displays the channel number used by this wireless device.
Mode
This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
supports.
Security Mode
This displays the type of security configured on the wireless device. OPEN means no
security is configured and you can connect to it without a password.
security is configured and you can connect to it without a password.
Strength
This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your NBG-418N and this device.
the antenna output power and the distance between your NBG-418N and this device.