ZyXEL Communications NBG-419N 用户手册
Chapter 10 WISP Mode
NBG-419N v2 User’s Guide
77
10.3.1 Setting your Router to WISP Mode
1
Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on
how to do this.
how to do this.
2
To set your Router to AP Mode, go to Maintenance > Sys OP Mode > General and select WISP
Mode.
Mode.
Figure 54
Changing to WISP mode
Note: You have to log in to the Web Configurator again when you change modes.As soon
as you do, your Router is already in WISP mode.
3
When you select WISP Mode, the following pop-up message window appears.
Figure 55
Pop up window for WISP mode
Click OK. The Web Configurator refreshes once the change to WISP mode is successful.
10.3.2 Accessing the Web Configurator in WISP Mode
To login to Web Configurator in WISP mode, do the following:
1
Connect your computer to the LAN port of the Router.
2
The default IP address of the Router is “192.168.1.1”. If you did not change this, you can use the
same IP address in WISP mode. Open a web browser such as Internet Explorer and type
“192.168.1.1” as the web address in your web browser.
same IP address in WISP mode. Open a web browser such as Internet Explorer and type
“192.168.1.1” as the web address in your web browser.
If you changed the IP address of your Router while in Router Mode, use this IP address in WISP
mode. The WISP mode IP address is always the same as the Router mode IP adderss.
mode. The WISP mode IP address is always the same as the Router mode IP adderss.