ZyXEL Communications 5 Series 用户手册
Chapter 33 Maintenance Screens
ZyWALL 5/35/70 Series User’s Guide
593
Figure 346 MAINTENANCE > Device Mode (Router Mode)
The following table describes the labels in this screen.
33.7 Configuring the Device Mode Screen (Bridge)
Click MAINTENANCE > Device Mode to open the following screen. Use this screen to
configure your ZyWALL as a router or a bridge.
configure your ZyWALL as a router or a bridge.
In bridge mode, the ZyWALL functions as a transparent firewall (also known as a bridge
firewall). The ZyWALL bridges traffic traveling between the ZyWALL's interfaces and still
filters and inspects packets. You do not need to change the configuration of your existing
network.
firewall). The ZyWALL bridges traffic traveling between the ZyWALL's interfaces and still
filters and inspects packets. You do not need to change the configuration of your existing
network.
Table 202 MAINTENANCE > Device Mode (Router Mode)
LABEL
DESCRIPTION
Current Device
Mode
Mode
Device Mode
This displays whether the ZyWALL is functioning as a router or a bridge.
Device Mode Setup
Router
When the ZyWALL is in router mode, there is no need to select or clear this radio
button.
button.
IP Address
Click LAN, WAN, DMZ or WLAN to go to the LAN, WAN, DMZ or WLAN screen
where you can view and/or change the corresponding settings.
where you can view and/or change the corresponding settings.
Bridge
Select this radio button and configure the following fields, then click Apply to set
the ZyWALL to bridge mode.
the ZyWALL to bridge mode.
IP Address
Enter the IP address of your ZyWALL in dotted decimal notation.
IP Subnet Mask
Enter the IP subnet mask of the ZyWALL.
Gateway IP
Address
Address
Enter the gateway IP address.
Apply
Click Apply to save your changes back to the ZyWALL. After you click Apply,
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
please wait for one minute and use the IP address you configured in the IP
Address field to access the ZyWALL again.
Reset
Click Reset to begin configuring this screen afresh.