ZyXEL Communications MES3500-24F 用户手册
Chapter 24 Multicast
MES3500-24/24F User’s Guide
198
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
Figure 100
Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
The following table describes the labels in this screen.
24.8.1 MVR Configuration Example
The following figure shows a network example where ports 1, 2 and 3 on the Switch belong to VLAN
1. In addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the
1. In addition, port 7 belongs to the multicast group with VID 200 to receive multicast traffic (the
Table 65
Advanced Application > Multicast > Multicast Setting > MVR: Group Configuration
LABEL
DESCRIPTION
Multicast
VLAN ID
VLAN ID
Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down list
box.
box.
Name
Enter a descriptive name for identification purposes.
Start Address
Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to
for more information on IP multicast addresses.
End Address
Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
address for a multicast group.
Refer to
for more information on IP multicast addresses.
Add
Click Add to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
MVLAN
This field displays the multicast VLAN ID.
Name
This field displays the descriptive name for this setting.
Start Address
This field displays the starting IP address of the multicast group.
End Address
This field displays the ending IP address of the multicast group.
Delete Select
Delete All or Delete Group and click Delete to remove the selected entry(ies) from
the table.
Cancel Select
Cancel to clear the checkbox(es) in the table.