ZyXEL Communications 202H 用户手册
Prestige 202H User’s Guide
26-20
VPN/IPSec Setup
Table 26-8
Menu 27.1.1.1 IKE Setup
FIELD DESCRIPTION
EXAMPLE
Perfect Forward
Secrecy (PFS)
Secrecy (PFS)
Perfect Forward Secrecy (PFS) is disabled (None) by default in phase 2
IPSec SA setup. This allows faster IPSec setup, but is not so secure. Press
[SPACE BAR] and choose from DH1 or DH2 to enable PFS. DH1 refers to
Diffie-Hellman Group 1 a 768 bit random number. DH2 refers to Diffie-
Hellman Group 2 a 1024 bit (1Kb) random number (more secure, yet slower).
IPSec SA setup. This allows faster IPSec setup, but is not so secure. Press
[SPACE BAR] and choose from DH1 or DH2 to enable PFS. DH1 refers to
Diffie-Hellman Group 1 a 768 bit random number. DH2 refers to Diffie-
Hellman Group 2 a 1024 bit (1Kb) random number (more secure, yet slower).
None
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save
your configuration, or press [ESC] at any time to cancel.
your configuration, or press [ESC] at any time to cancel.
26.12 Manual Key Setup
You only configure Menu 27.1.1.2 – Manual Setup when you select Manual in the Key Management field
in Menu 27.1.1 – IPSec Setup. Manual key management is useful if you have problems with IKE key
management.
in Menu 27.1.1 – IPSec Setup. Manual key management is useful if you have problems with IKE key
management.
26.12.1 Active
Protocol
This field is a combination of mode and security protocols used for the VPN. These parameters were
discussed earlier.
discussed earlier.
Table 26-9 Active Protocol: Encapsulation and Security Protocol
MODE SECURITY
PROTOCOL
Tunnel ESP
Transport AH
26.12.2
Security Parameter Index (SPI)
An SPI is used to distinguish different SAs terminating at the same destination and using the same IPSec
protocol. This data allows for the multiplexing of SAs to a single gateway. The SPI (Security Parameter
Index) along with a destination IP address uniquely identify a particular Security Association (SA). The SPI
is transmitted from the remote VPN gateway to the local VPN gateway. The local VPN gateway then uses
the network, encryption and key values that the administrator associated with the SPI to establish the tunnel.
protocol. This data allows for the multiplexing of SAs to a single gateway. The SPI (Security Parameter
Index) along with a destination IP address uniquely identify a particular Security Association (SA). The SPI
is transmitted from the remote VPN gateway to the local VPN gateway. The local VPN gateway then uses
the network, encryption and key values that the administrator associated with the SPI to establish the tunnel.
Current ZyXEL implementation assumes identical outgoing and incoming SPIs.
To edit this menu, move the cursor to the Edit Manual Setup field in Menu 27.1.1 – IPSec Setup press
[SPACE BAR] to select Yes and then press [ENTER] to go to Menu 27.1.1.2 – Manual Setup.
[SPACE BAR] to select Yes and then press [ENTER] to go to Menu 27.1.1.2 – Manual Setup.