ZyXEL Communications 202H 用户手册
Prestige 202H User’s Guide
Remote Node Configuration
8-9
Table 8-3 Menu 11.2 Remote Node PPP Options
Target Utility (Kbps) Enter the two thresholds separated by a [–] for subtracting
and adding the second port.
Default = 32–48
Add Persist This parameter specifies the number of seconds where
traffic is above the adding threshold before the Prestige
will bring up the second link.
will bring up the second link.
Default = 5 sec
Subtract Persist This parameter specifies the number of seconds where
traffic is below the subtraction threshold before your
Prestige drops the second link.
Prestige drops the second link.
Default = 5 sec
Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.
save your configuration, or press [ESC] at any time to cancel.
8.7 LAN-to-LAN
Application
A typical LAN-to-LAN application is to use your Prestige to connect a branch office to the headquarters, as
depicted in the following diagram.
depicted in the following diagram.
Figure 8-4 TCP/IP LAN-to-LAN Application
For the branch office, you need to configure a remote node in order to dial out to headquarters.