AmbiCom WL250N-AR 用户手册

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC 

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will 

not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or 

more of the following measures:     

1.  Reorient or relocate the receiving antenna. 

2.  Increase the separation between the equipment and receiver. 

3.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

4.  Consult the dealer or an experienced radio technician for help. 

This equipment must be installed and operated in accordance with provided instructions and a minimum 20 cm spacing must 

be provided between computer mounted antenna and person’s body (excluding extremities of hands, wrist and feet) during 

wireless modes of operation. 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may 

not cause harmful interference, and (2) this device must accept any interference received, including interference that may 

cause undesired operation. 

Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to 

operate equipment. 

This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the 

possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm 

(8 inches) during normal operation. 

The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or 

transmitter. 

The equipment version marketed in US is restricted to usage of the channels 1-11 only.