Siemens SM2 monitoring system 用户手册
58
U3585-J-Z125-8-76
Starting and terminating SM2
SM2 operation
MONJV =
Specifies the name of the job variable to be monitored in the SM2 run. The job variable must
already be cataloged.
Specifies the name of the job variable to be monitored in the SM2 run. The job variable must
already be cataloged.
MONJV = *NONE
No job variable is specified.
No job variable is specified.
MONJV = <filename 1..54 without-gen-vers>
Specifies the name of a job variable already cataloged.
Specifies the name of a job variable already cataloged.
CPU-LIMIT =
Specifies the CPU time required for the SM2 run. In interactive mode, the user is notified by
the system if this time is exceeded. In batch mode, the SM2 run is terminated.
Specifies the CPU time required for the SM2 run. In interactive mode, the user is notified by
the system if this time is exceeded. In batch mode, the SM2 run is terminated.
CPU-LIMIT = *JOB-REST
There is no limit on the CPU time available to the program.
There is no limit on the CPU time available to the program.
CPU-LIMIT = <integer 1..32767>
Specifies the CPU time required for the SM2 run.
Specifies the CPU time required for the SM2 run.
4.1.2
Terminating the program
SM2 is terminated using the END statement.
●
The automatic output mode is terminated with the BREAK function. The END statement
is entered after returning to program mode (using /INFORM-PROGRAM).
is entered after returning to program mode (using /INFORM-PROGRAM).
●
In controlled mode, END can be entered instead of an output control character just like
any other output statement.
any other output statement.
SM2 acknowledges program termination with the message
SM2 TERMINATED NORMALLY.
Note
Monitored data acquisition is never terminated by the END statement. Termination of
the SM2 subsystem is only possible by explicitly issuing the command
/STOP-SUBSYSTEM SUBSYSTEM-NAME=SM2.
the SM2 subsystem is only possible by explicitly issuing the command
/STOP-SUBSYSTEM SUBSYSTEM-NAME=SM2.