EnGenius Technologies EAP9550 用户手册

下载
页码 46
Appendix A – 
FCC Interference Statement 
 
Federal Communication Commission Interference Statement 
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part  15  of  the  FCC  Rules.    These  limits  are  designed  to  provide  reasonable  protection  against  harmful 
interference  in a  residential  installation.    This equipment  generates, uses  and  can radiate  radio  frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio  communications.    However,  there  is  no  guarantee  that  interference  will  not  occur  in  a  particular 
installation.    If this equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by 
one of the following measures: 
 
 
Reorient or relocate the receiving antenna. 
 
Increase the separation between the equipment and receiver. 
 
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
 
Consult the dealer or an experienced radio/TV technician for help. 
 
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) 
This device may not cause harmful interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation. 
 
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance 
could void the user's authority to operate this equipment. 
 
IMPORTANT NOTE: 
FCC Radiation Exposure Statement: 
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This 
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.     
 
We declare that the product is limited in CH1~CH11 by specified firmware controlled in the USA. 
This  transmitter  must  not  be  co-located  or  operating  in  conjunction  with  any  other  antenna  or 
transmitter.