Benq SH910 用户手册
Operation
38
•
Menu display time in the SYSTEM SETUP: Basic > Menu Settings menu sets the length
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
of time the OSD will remain active after your last key press. The time length ranges from
5 to 30 seconds in 5-second increments. Use
/
to select a suitable time frame.
•
Menu position in the SYSTEM SETUP: Basic > Menu Settings menu sets the OSD
position in five locations. Use
position in five locations. Use
/
to select a preferred position.
•
Language in the SYSTEM SETUP: Basic menu sets your familiar language for the OSD
menus. Use
menus. Use
/
to select your language.
•
Reminder Messge in the SYSTEM SETUP: Basic >Menu Settings menu sets whether to
display reminder messages on screen. Use
display reminder messages on screen. Use
/
to select your desired setting.
Shutting down the projector
1.
Press
Power and a confirmation message
displays prompting you. If you don't respond
in a few seconds, the message will disappear.If
you use the remote control, press OFF to shut
down the projector.
in a few seconds, the message will disappear.If
you use the remote control, press OFF to shut
down the projector.
2.
Press
Power a second time. The POWER
indicator light flashes red, the projection lamp
shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the
projector.
shuts down, and the fans will continue to run
for approximately 90 seconds to cool down the
projector.
•
To protect the lamp, the projector will not respond
to any commands during the cooling process.
to any commands during the cooling process.
3.
Once the cooling process finishes, the POWER indicator light is a steady red and fans
stop.
stop.
4.
Disconnect the power cord from the power putlet if the projector will not be used in
an extended period of time.
an extended period of time.
•
If the projector is not properly shut down, to protect the lamp, when you attempt to re-start
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns red.
the projector, the fans will run for a few minutes to cool down. Press Power again to start
the projector after the fans stop and the POWER indicator light turns red.
•
Actual lamp life may vary due to different environmental conditions and usage.
I
I
I
I