Runco Vision 85 用户手册
32
Vidikron Vision 85 Owner’s Operating Manual
PRE
L
IMINAR
Y
3.9
Installing and Adjusting
the CineWide Anamorphic
Lens
Installing and Adjusting
the CineWide Anamorphic
Lens
If you are installing a CineWide-equipped projector, proceed as follows to install and adjust
the anamorphic lens.
the anamorphic lens.
The standard Vision 85/CineWide uses a prismatic-style anamorphic lens. This type of lens
compresses the height of the image (as opposed to stretching the width) to achieve a 2.35:1
aspect ratio with a 1.78:1 display device.
compresses the height of the image (as opposed to stretching the width) to achieve a 2.35:1
aspect ratio with a 1.78:1 display device.
The standard Vision 85 Anamorphic lens mount kit consists of everything shown in Figure
3-16. Some components shipped with your projector may differ slightly from what is shown
in these instructions.
3-16. Some components shipped with your projector may differ slightly from what is shown
in these instructions.
If any items are missing or damaged, please contact your Vidikron dealer or Vidikron
Customer Service at (888) 4VIDIKRON.
Customer Service at (888) 4VIDIKRON.
Figure 3-16. Vision 85 Anamorphic Lens Mounting Assembly - Exploded View
1.
Use the Pitch Adjustment Screws (item #3) and Washers (item #6) to attach the Mounting
Brackets (item #2) to the Anamorphic Lens (item #1).
Brackets (item #2) to the Anamorphic Lens (item #1).
2.
Use the four Y-Adjustment Screws (item #5) and Washers (item #4) to attach the
Anamorphic Lens assembly and Spacers (item #7) to the front of the projector. (Do not
fully tighten the screws yet.)
Anamorphic Lens assembly and Spacers (item #7) to the front of the projector. (Do not
fully tighten the screws yet.)
It is extremely important that the primary lens is properly adjusted
before you install the anamorphic lens. Ensure that the image from
the primary lens is perfectly centered on the screen.
before you install the anamorphic lens. Ensure that the image from
the primary lens is perfectly centered on the screen.
Note
2 Base Plate
5 Vertical Mounting
Bracket (2x)
Bracket (2x)
6 Pitch/Y-Adjustment
Screw, Phillips
Pan Head, 4-40 x 3/8” (2x)
and Fender Washer (2x)
Screw, Phillips
Pan Head, 4-40 x 3/8” (2x)
and Fender Washer (2x)
4 Yaw/Z-Adjustment
Lever (2x) and
Fiber Washer (2x)
Lever (2x) and
Fiber Washer (2x)
1 Anamorphic Lens
3 Screw, Phillips
M6x16mm (4x) and
1/4” Flat Washer (4x)
(not shown; secures Base Plate
to bottom of projector)
M6x16mm (4x) and
1/4” Flat Washer (4x)
(not shown; secures Base Plate
to bottom of projector)