Runco CL-810 用户手册
14
Runco CL-810 Owner’s Operating Manual
Connector Panel
Controls and Functions
Runco Logo
To access the connector panel, pull
firmly on the cable access cover to
open it.
firmly on the cable access cover to
open it.
1. HDMI (High-Definition Multimedia Interface) Input
Digital video signal input
2. Component (RCA Jacks)
480i Component (Y/CB/CR) video signal input
3. Video (RCA Jack)
Composite video signal input
4. S-Video (mini DIN 4-pin) Y/C (S-video) signal input
5. RS-232C (RJ-11 Jack)
RS-232C control signal input (refer to page 49 for details)
6. 12v Trigger (mini jack, diameter 5.5 mm outside, 2.5 mm inside)
+12V output, active when the projector is turned on
7. RGB/ HDTV (BNC) or Progressive Scan DVD players
DTV Y/P
B
/P
R
or DTV RGB video signal input
The Runco logos on the front and rear of the projector
can be rotated to match a floor or ceiling installation.
To rotate the logo, grip it at the sides, pull it away
from the projector and rotate it 180 degrees.
can be rotated to match a floor or ceiling installation.
To rotate the logo, grip it at the sides, pull it away
from the projector and rotate it 180 degrees.
S-VID /
S-VID