Runco VX-22D 用户手册
Runco VX-22d Owner’s Operating Manual
39
PRE
L
IMINAR
Y
3.11
Installing and
Adjusting the
CineWide Anamorphic
Lens
Installing and
Adjusting the
CineWide Anamorphic
Lens
If you are installing a CineWide-equipped projector, proceed as follows to install and
adjust the anamorphic lens.
adjust the anamorphic lens.
Attach Lens Mounting
Assembly to Lens Motor
Carriage Plate
Assembly to Lens Motor
Carriage Plate
The VX-22d Anamorphic lens mount kit consists of everything shown in Figure 3-16.
Some components shipped with your projector may differ slightly from what is shown in
these instructions. If any items are missing or damaged, please contact your Runco dealer
or Runco Customer Service at (800) 23-RUNCO.
Some components shipped with your projector may differ slightly from what is shown in
these instructions. If any items are missing or damaged, please contact your Runco dealer
or Runco Customer Service at (800) 23-RUNCO.
Figure 3-16. VX-22d Anamorphic Lens Mounting Assembly - Exploded View
1.
Remove the two Yaw/X Adjustment Levers (item #8) from the bottom of the
Anamorphic Lens Holder (item #5).
Anamorphic Lens Holder (item #5).
2.
Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate (item #7).
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
Position the bracket so that the long slot at the bottom of the lens holder is
perpendicular to the corresponding slots on the carriage plate.
3.
Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers
(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
(item #6) and Yaw/X Adjustment Levers that you removed in Step 1.
It is extremely important that the primary lens is properly
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
adjusted before you install the anamorphic lens. Ensure that
the image from the primary lens is perfectly centered on the
screen.
Note
2
3
4
6
7
8
5
1
9
Pitch Adjustment Yoke for Lens
Height/Y Adjustment
T-Screw (2x)
T-Screw (2x)
T-Screw (2x)
Pitch Adjustment
Anamorphic Lens
Holder
Holder
1/4-20 Hex Bolt (2x)
and Washer (2x)
and Washer (2x)
AutoScope Carriage Plate
Yaw/X Adjustment
Lever (2x)
Lever (2x)
Lens Adapter Ring and
Mounting Screws (3x)
Mounting Screws (3x)
Pitch Adjustment
T-Nut (2x)
T-Nut (2x)
10
Anamorphic Lens
Set Screw
Set Screw