Runco CL-810 CINEWIDE 用户手册

Table 3-1 gives a quick overview of the CL-810 installation process. The sections 
following this one provide detailed instructions. 

1

Choose a location for the projector

2

If installing a CL-810 Ultra/CineWide with AutoScope: 
Install AutoScope lens motor (optional) 

3

Mount the projector

4

If installing with an SDC-1, connect ONLY the SDC-1 
output to the CL-810 and make all other connections to the 
SDC-1; continue with Step 7
-- OR --
If installing without an SDC-1, connect signal sources to 
the CL-810 and continue with Step 5 

5

Connect external controller to RS-232 port (optional)

6

Connect 12-volt trigger output to AutoScope lens motor or 
other equipment (optional)

7

Apply power to the projector

8

Change the OSD Language (optional)

9

For rear-screen and/or ceiling-mount installations, select 
the proper picture orientation 

10

Primary lens adjustments: projected image size (zoom), 
position (shift) and focus

18, 33

11

Install CineWide anamorphic lens (optional)

12

CineWide lens adjustments: position, pitch (angle), 
geometry and focus

13

Projector calibration: adjust the following for each input; 
save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color level
• Tint
• Input position

53 through 59