Runco SC-1 用户手册

Table 3-1 gives a quick overview of the SC-1 installation process. The sections following 
this one provide detailed instructions. 

 

1

Choose a location for the projector

2

Install primary projection lens, lamp and heat extractor

3

Install CineWide lens mounting assembly (stationary base 
plate or AutoScope lens motor – optional)

4

Mount the projector

5

Connect the DHD Controller to the projector

6

Connect signal sources to the DHD Controller

7

Connect external controller to RS-232 port (optional)

8

Connect AutoScope lens motor and/or other equipment to 
12-volt trigger outputs (optional)

9

Connect power supply/lamp ballast, if separate from 
projection head (split-body configuration) 

10

Apply power to the projector 

42, 43

11

For rear-screen installations, select the proper picture 
orientation 

12

Primary lens adjustments: projected image size (zoom), 
position (shift) and focus

22, 46

13

Install CineWide anamorphic lens (optional)

14 CineWide lens adjustments: p

osition, pitch (angle), 

geometry and focus

15

Calibrate projector input 1 (RGBHV): perform Auto Setup, 
then adjust size/position, input levels, brightness/contrast 
etc., as needed

16

Repeat Step 15 for projector Input 2 (DVI), if used

17

Adjust lamp output, as needed

18

DHD Controller input calibration: adjust the following for 
each DHD Controller input, starting with Component 
SD; save settings when finished:
• Aspect ratio

• Color level

• Brightness

• Tint

• Contrast

• Input position

69 through 76