Runco DTV-947 用户手册
3-3
Connections
GENERAL ACCESS
SHARPNESS
TINT
COLOR
BRIGHTNESS
CONTRAST
TINT
COLOR
BRIGHTNESS
CONTRAST
5
6
3
4
1
2
Enter ADJUST
Select with ,
or
then <ENTER>.
<EXIT> to return
FROM LOCAL KEYPAD
VCR S-VIDEO or DVD
Luma / Chroma
RS232 IN
RS232 OUT
IR
COMM PORT
REMOTE
R G(s) B H V VIDEO S - VIDEO
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
the FCC rules. Operation is subject to
following two conditions (1), This
device may not cause harmful inter-
ferance, and (2) this device must
accept any interferance received
including interferance that may cause
undesired operation.
Connecting an S-Video or Video source to the S-Video input
Separate Y-luma/C-Chroma signals for higher quality playback of Super
VHS signals.
VHS signals.
Note: S-video should normally be connected to the controller.
Input selection
a. with the RCU: Select “S-Video” in the source selection menu.
b. with the local keypad
- press ADJUST key, the General access menu will be dis
played on the screen.
- use the control disk to highlight 2.
- press ENTER to select the highlighted source.
- press ENTER to select the highlighted source.
4 pin connector configurations:
For S-video:
Pin 1: earth(ground) luminace
Pin 2: earth(ground) chrominance
Pin 3: luminance signal(Y)
Pin 2: earth(ground) chrominance
Pin 3: luminance signal(Y)
1Vpp+3dB
Pin 4: chrominance signal(C)
300mVpp+3dB
300mVpp+3dB
_
_
For video:
Pin 1: earth(ground) video
Pin 2: not connected
Pin 3: video signal
Pin 4: not connected
Pin 2: not connected
Pin 3: video signal
Pin 4: not connected