Runco VX-40d 用户手册
46
Runco VX-40d/-50d/-60d/-80d Owner’s Operating Manual
PRE
L
IMINAR
Y
To display the Channel Setup menu, press 3 or highlight Channel Setup and press
ENTER or
ENTER or
. The Channel Setup menu appears with the active channel highlighted.
WHAT APPEARS IN THE CHANNEL SETUP MENU? This menu lists all channels
defined so far and indicates where they are connected on the input panel.
defined so far and indicates where they are connected on the input panel.
The far left column lists channel numbers currently defined.
The values in the far right columns indicate horizontal and
vertical frequencies — if someone has defined a name for this
channel, it appears here instead. Remaining columns contain
details pertaining to each channel setup, such as its switcher
number (always 0 = projector), slot location, a variety of icons indicating access to each
channel, and an abbreviated description of each signal type.
The values in the far right columns indicate horizontal and
vertical frequencies — if someone has defined a name for this
channel, it appears here instead. Remaining columns contain
details pertaining to each channel setup, such as its switcher
number (always 0 = projector), slot location, a variety of icons indicating access to each
channel, and an abbreviated description of each signal type.
Signal Type Abbreviations: The Channel Setup menu identifies signal types in a
shortened form. These descriptors indicate what signal information the projector uses to
identify a match for a given channel, and are preceded by either an “i” (for interlaced
signals) or “p” (for progressive signals).
shortened form. These descriptors indicate what signal information the projector uses to
identify a match for a given channel, and are preceded by either an “i” (for interlaced
signals) or “p” (for progressive signals).
When used with the DHD Controller, the RGB-HV output signal is represented by “p5W”
or “i5W.” The DVI output signal is either “pDig” or “iDig.”
or “i5W.” The DVI output signal is either “pDig” or “iDig.”
Copying Channels: Channels are pre-configured at the Runco factory for use with the
DHD Controller, and are locked to prevent the factory settings from being over-written
accidentally. Before proceeding with calibration, copy the existing channel for the current
input to a new channel so that any changes you make are stored in that channel.
DHD Controller, and are locked to prevent the factory settings from being over-written
accidentally. Before proceeding with calibration, copy the existing channel for the current
input to a new channel so that any changes you make are stored in that channel.
To copy a channel:
1. Select Channel Setup from the Main Menu to display the Channel Setup menu.
2. Highlight the channel you want to copy in the Channel Setup menu.
3. Press FUNCN (or DIS) to go to the Channel Copy/Delete submenu.
4. Select Copy and press ENTER. This creates a new channel that is identical to the
original – which remains – but it is identified with the next available number from 01 to
50. If you change your mind and do not want to copy the current channel, press EXIT
to cancel and return to the previous menu. Copying channels is a quick way to create
numerous channels, each of which can then be edited and adjusted for a variety of
presentations in the future.
50. If you change your mind and do not want to copy the current channel, press EXIT
to cancel and return to the previous menu. Copying channels is a quick way to create
numerous channels, each of which can then be edited and adjusted for a variety of
presentations in the future.
Figure 3-17. Copying a Channel
FUNCN