Runco VX-4000d 用户手册
Runco VX-4000d/VX-5000d Owner’s Operating Manual
19
PRE
L
IMINAR
Y
3.1
Remote Control
Remote Control
Battery Installation
To install batteries in the remote control:
1.
Remove the battery cover from
the back of the remote control.
the back of the remote control.
2.
Insert the batteries included
with the remote control. Ensure
that the polarities correctly
match the
with the remote control. Ensure
that the polarities correctly
match the
and
markings
inside the battery compartment.
3.
Replace the battery cover.
With the touch-screen
remote: After a few seconds,
the remote starts up
automatically and an
Introduction screen appears.
The remote control beeps twice to indicate that it has started up successfully.
Notes on Remote Control
Operation
Operation
The remote control can be used to control the VX-4000d/VX-5000d within the ranges
shown in Figure 3-1.
shown in Figure 3-1.
Figure 3-1. Available Range of the Remote Control
3. Installation
1. Do not mix an old battery with a new one or different types of
batteries.
2. If you will not use the remote control for a long time, remove the
batteries to avoid damage from battery leakage.
Touch-Screen Remote
Standard DHD Remote
Note
Approx.
7m / 23ft
Approx.
30m / 100ft