Toshiba TLP-T700 用户手册
39
Operations
38
3
Select the projector to be operated.
In the Remote Control window, click on the
button, and
select the desired projector from the pull-down list.
Only one projector can be selected. (It is not possible to operate
multiple projectors.)
Then icon
Only one projector can be selected. (It is not possible to operate
multiple projectors.)
Then icon
is displayed on the projector’s screen for few
seconds.
4
Click on the Remote Control window’s buttons.
The function of each button and box is as follows:
Power On:
Power On:
Turns projector power on.
Power Off:
Turns projector power off.
Note, however, that if Standby mode is set to Economy from the
Default setting menu
Note, however, that if Standby mode is set to Economy from the
Default setting menu
, it is not possible to switch from off to on.
(Standby power consumption during Economy is about 6W.)
Input (box) :
Click on the
button, and select the desired input from the pull-down
list.
Mute:
Cuts off picture and sound. Click again to restore picture and sound.
Freeze:
The picture is paused. Click again to release the freeze function.
Volume (+/–) : Adjusting sound volume.
Resize (+/–) : Displays expanded image.
↑↑↑↑↑/↓↓↓↓↓/←
Resize (+/–) : Displays expanded image.
↑↑↑↑↑/↓↓↓↓↓/←
←
←
←
←/→
→
→
→
→:
Moves expanded image.
Resize Off:
Restores picture to its original size.
5
To quit, click on the
button on the Remote Control window.
Performing this does not close the Wireless Utility window.
To exit both the Wireless Utility and the Remote Control, click on the
button on
the Wireless Utility window.
5
Select the projector to be transmitted.
A list of the MAC addresses of the wireless LAN
PC cards
PC cards
,
mounted on the projectors
that are available for transmission appears. If
projector name has been set up already, it is
shown instead of the MAC address. Select the
checkbox of the projector to be transmitted to from
this list. Then icon
projector name has been set up already, it is
shown instead of the MAC address. Select the
checkbox of the projector to be transmitted to from
this list. Then icon
is displayed on the
projector’s screen for few seconds.
It is possible to select up-to four projectors.
It is possible to select up-to four projectors.
6
Click on the
button.
The selected file’s image is displayed by the projector.
Note
• Only one file can be sent at a time. To send another file, repeat steps
4
and
6
.
■ Operating the projector
This function can be used with any projector input.
Note, however, that this will not function with a memory PC card.
Note, however, that this will not function with a memory PC card.
1
Launch the Wireless Utility software application.
The Screen Image transmission mode window appears on the computer’s screen.
2
Click on the Remote Control
button
.
The Remote Control window
appears.
appears.
As the Wireless Utility window is still
displayed, you can operate the
projector via the Remote Control
window, while using the Wireless
Utility’s functions.
displayed, you can operate the
projector via the Remote Control
window, while using the Wireless
Utility’s functions.
While it is possible to use this function merely to operate the projector, closing the
Wireless Utility also closes the Remote Control window.
Wireless Utility also closes the Remote Control window.
Using the wireless LAN PC card (Continued)