Toshiba TLP-T60M 用户手册

31

30

You can call up on-screen menus, and conduct a number of adjustments and settings using
the operation buttons 

 on the control panel (main unit side) and remote control.

■ How to use the menus

The menu shown below is only for operation instructions and might be different from the
actual display.

• Menu adjustments and settings are saved when the power is turned off via the ON/

STANDBY button. If the power cable is disconnected before this, or the power goes out,
then the data will not be saved.

• You can also use the CANCEL button on the remote control to dismiss the menu display.

Display the Setting display menu

To Status display

The menu disappears.

Finish via the Status 
display menu.

Select a category by using           .

There are following three 
categorys.

Displays the current 
adjustments of selected 
category.
Item shown with gray 
cannot be adjusted with 
the current input source.

Image adjustment menu

Default setting menu

Display setting menu

The figure shows a typical example.  
As the display may differ depending 
on the item, use the following pages 
as a reference.

Item

Adjustment/Setting Value

This mark signfy that 
there are options.
Press        to display a 
list of options.

These marks signify the 
items can be adjusted/set 
by using                .

These marks signify an 
item can be switched by 
using                .

These marks signify the items can be selected from 
the list by using            .
After an item is selected, apply it by pressing      .

Press      to open the menu 
of the selected category.

■ Displaying Information [Status display]

This displays information about the input signal, lamp use time, etc.

When the 

 button is pressed once, the Setting

display menu appears. Pressing it again displays
information 

. The table below shows what kind

of information is displayed. Press the 

 button (or

press the CALL or CANCEL button on the remote
control to serve the same purpose) again to
dismiss the display.

“Yes”: displayed, “No”: not displayed

Item

Description

Computer Y/P

B

/P

R

Video

Camera

S-video

Input

Input source name

Yes

Yes

Yes

Yes

RGB signal mode RGB input mode 

[Note 1]

Yes

No

No

No

H-resolution

Horizontal resolution (in bits)

Yes

No

No

No

V-resolution

Vertical resolution (in bits)

Yes

No

No

No

H-frequency

Horizontal sync frequency

Yes

No

No

No

V-frequency

Vertical sync frequency 

[Note 2]

Yes

No

No

No

Sync

Sync signal polarity 

[Note 3]

Yes

No

No

No

Signal format

Y/P

B

/P

R

 signal format

No

Yes

No

No

Video mode

Color method of video signal

No

No

Yes

No

Lamp time

Time of lamp use 

[Note 4]

Yes

Yes

Yes

Yes

Version

Firmware version 

[Note 5]

Yes

Yes

Yes

Yes

Notes
1: The mode of supported RGB signals 

 is shown.

2: Same as the refresh rate of the computer signal.
3: Sync signal polarity shown as P (positive) or N (negative) for [H/V].
4: Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be

used as a counter of guaranteed lamp time.) When the displayed time approaches 3,000
hours, consult with a store about getting a TLPLV2 replacement lamp (sold separately)
prepared.

5: [Version] shows the version of the projector’s internal control program. This version is

referred to for customer service, etc.

• The displayed information will not be refreshed if the status changes. To refresh the

information, dismiss the display, then display it again.

• Conducting another operation while information is being displayed dismisses the

display.