Sanyo PLC-XD2600 用户手册

Unplug the AC power cord before cleaning.

Gently  wipe  the  projection  lens  with  a  cleaning  cloth  that

contains  a  small  amount  of  non-abrasive  camera  lens

cleaner,  or  use  a  lens  cleaning  paper  or  commercially

available air blower to clean the lens.

Avoid  using  an  excessive  amount  of  cleaner. Abrasive

cleaners,  solvents,  or  other  harsh  chemicals  might  scratch

the surface of the lens.

Unplug the AC power cord before cleaning.

Gently wipe the projector body with a soft dry cleaning cloth.

When the cabinet is heavily soiled, use a small amount of

mild detergent and finish with a soft dry cleaning cloth. Avoid

using  an  excessive  amount  of  cleaner. Abrasive  cleaners,

solvents, or other harsh chemicals might scratch the surface

of the cabinet.

When  the  projector  is  not  in  use,  put  the  projector  in

an  appropriate  carrying  case  to  protect  it  from  dust  and

scratches.

When  moving  this  projector  or  while  not  using  it  over  an

extended period of time, replace the lens cap.

Attach the lens cap according to the following procedures.

Thread the string through the hole on the lens cap and

then tie a knot in the string to secure it in place.

To pass the other end of the string into the hole on the

bottom of the projector and pull at it.

Do not use any flammable solvents or air sprays on the

projector  and  in  its  vicinity. The  explosion  or  fire  hazard

may  occur  even  after  the AC  power  cord  is  unplugged

because the temperature inside the projector is extremely

high due to the lamps. In addition, there is a risk that the

internal parts may be damaged not only by the flammable

air spray but also by the cold air.