Toshiba NPS10A 用户手册
18
Loading a coin cell battery into the
remote control
remote control
Notes
When you use for the first time after
purchase, a plastic sheet is provided
between the battery and its contact.
Be sure to remove by pulling it off.
When operating the remote control
from behind the projector, the infrared
beam is reflected on the projecting
surface and may travel a shorter dis-
tance to reach the projector depend-
ing on the shape and material of the
projecting surface.
purchase, a plastic sheet is provided
between the battery and its contact.
Be sure to remove by pulling it off.
When operating the remote control
from behind the projector, the infrared
beam is reflected on the projecting
surface and may travel a shorter dis-
tance to reach the projector depend-
ing on the shape and material of the
projecting surface.
Operating the remote control
Point toward the projector’s infrared
remote sensor, and press a button on
the remote control.
Operating the projector from the front
Point toward the projector’s infrared
remote sensor, and press a button on
the remote control.
Operating the projector from the front
Approx. 7m
Approx.15°
Remove the battery holder.
Hold down the side release firmly and
pull out the battery holder.
pull out the battery holder.
Load a coin cell battery (CR2025).
Be sure to align the plus and minus
ends of the battery properly.
ends of the battery properly.
3
V
OL
TS
CR2
02
5
Replace the battery holder back into
the remote control.
M
3
VO
LT
S
CR
20
25
Preparing and using the remote control
Coin cell battery
Before using the battery, be sure to observe the Safety Precautions described in
previous pages.
Remove the battery from remote control when not using for extended periods.
If the remote control stops working, or if its range decreases, replace the battery with
a new one.
Keep the battery away from the reach of children. Battery is choking hazard and can
be very dangerous if swallowed. If the battery is swallowed, seek medical assistance
immediately.
The remote control
The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fluorescent lighting.
Do not drop or bang.
Do not leave in hot or humid locations.
Do not allow it to get wet or place it on top of wet objects.
Do not take apart.
In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the opera-
tion.
Before using the battery, be sure to observe the Safety Precautions described in
previous pages.
Remove the battery from remote control when not using for extended periods.
If the remote control stops working, or if its range decreases, replace the battery with
a new one.
Keep the battery away from the reach of children. Battery is choking hazard and can
be very dangerous if swallowed. If the battery is swallowed, seek medical assistance
immediately.
The remote control
The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fluorescent lighting.
Do not drop or bang.
Do not leave in hot or humid locations.
Do not allow it to get wet or place it on top of wet objects.
Do not take apart.
In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the opera-
tion.