Toshiba TDP-MT700 用户手册

Using the projector and remote control  

20

 

Follow the steps below.
1.

Make sure the Power light is orange after power has been applied 
and the main AC power switch is turned on. 

2.

Press and hold the ON/STANDBY button on the projector or 
remote control to turn the projector on.

3.

The fans will be up and running. A start-up image shows on the 
screen for a few seconds. 

4.

"Searching…." will be displayed on the screen before the projec-
tor identifies the input signal. This message will remain on the 
screen until a valid signal is detected.

5.

If the horizontal frequency of the input signal exceeds the range of the projector, a message 
reading " Unsupported timing" will be displayed on the screen. This message will remain on-
screen until you change the input signal.

The projector can be connected to multiple equipment at the same 
time. To sequentially select input signals, press one of the INPUT but-
tons on the remote control or INPUT on the projector.

Q

When the projector is turned on, it will search for the input source 
you last selected.

Q

If you need to use the PIP or POP function, refer to 

 for 

advanced operation.

1.

Turn all of the connected equipment on.

2.

Remove the lens cap. 

3.

Plug the supplied power cord into the AC inlet on 
the rear of the projector and turn the main AC 
power switch on. 

4.

Plug the power cord into a wall socket and turn 
the wall switch on.