Sharp XV-Z9000E 用户手册

• Projector power cord is not plugged into the wall outlet.
• Selected input is wrong. (See page 23.)
• Cables incorrectly connected to back panel of the projector. (See pages 13–15.)
• Remote control batteries have run down. (See page 11.)
• “Contrast” and “Brightness” adjustments are set to minimum position. (See page 29.)

• “Color” and “Tint” adjustments are not correct. (See page 29.)

• Adjust the focus. (See page 17.)
• Projection distance is too long or too short to allow for proper focus. (See pages 20 and 21.)

• OSD Display is set to “Level A” or “Level B”, preventing to display some or all On-screen

Displays. (See page 37.)

• If the picture is normal, the sound is due to cabinet shrinkage caused by temperature

changes. This will not affect operation or performance.

• Refer to “Lamp/Maintenance Indicators” on page 45.

• Adjust the “Phase” setting. (See page 32.)
• Noise may appear when used with certain computers. Set the NOISE FILTER to ON

using the RS-232C command. (See pages 52–54.)

• Change the input signal type. (See page 31.)

No picture appears.

Colour is faded or poor.

Picture is blurred.

No OSD appears.

An unusual sound is occasion-
ally heard from the cabinet.

Maintenance indicator lights
up.

Picture noise appears.

Image is green on INPUT 1 or
2 COMPONENT.
Image is pink (no green) on
INPUT 1, 2 RGB.