Texas Instruments DU9000 用户手册

®

 

Start Using the Projector

There are 10 display modes, 6 preset and 4 user assigned,  that can be used to adjust the display.  Preset 

modes include:  Picture/Brightness/Contrast/Saturation/Hue/Sharpness.  The user assigned modes are as-

signed by the user and memorized by the system. 

This function is same as the shortcut key on the remote control. You can use the remote control or this func-

tion to select the correct input source.

 

HDMI input from PC or media equipment.

SDI input from PC or media equipment.

 

RGB signal from PC.

 

Analog interface in media equipment.

 

HDBaseT output of PC, media equipment or HDbaseT transmitter.

You can use this function to set auto synchronization for the input signal.

Set the 3D format and sync method. The projector detects the type of the connected input signal and  

provides relevant options for setting. The unavailable option is displayed using light green texts. Before per-

forming 3D setting, make sure that the input signal is connected. When there's no input signal, no 3D setting 

shall be performed.

Select this option and press the Enter button to enable 3D replay and set 3D option.

•  Off 

Turn off the 3D Display Mode. When Auto, Side by Side, Top/Bottom or Frame Sequential is selected, the 

3D Mode will be turned on. To turn off the 3D Mode, select "Off" and press the Enter button. 

•  Auto 

Enable the 3D format to automatically detect the formats of Frame Packing, Top/Bottom and Side by Side. 

This function may only be enabled for the input signal below: 

The input signal is HDMI 1.4a 3D. 

The HDMI 1.4a 3D signal connects to the projector through the HDBaseT transmitter. 

•  Side by Side(Half) 

Manually switch the 3D Format to Side by Side. This option is only applicable to the HDMI input signal or 

the HDMI signal sent by using the HDBaseT transmitter.    

•  Top/Bottom: Manually switch the 3D Format to Top/Bottom. This option is only applicable to the   

HDMI input signal or the aforementioned signal sent through the HDMior HDBaseT transmitter. 

Set to activate or deactivate the DLP Link sync.