Fisher PDG-DWT50KL 用户手册

 

iv 

Compliance 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal-
lation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in 
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee 
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tele-
vision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 

−  Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. 

−  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 

−  Consult the dealer or an experienced radio/TV technician for help. 
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules. 
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such changes 
or modifications should be made, you could be required to stop operation of the equipment. 

Model Number(s) 

: PDG-DWT50L 

Trade Name 

: Sanyo 

Responsible party 

: SANYO FISHER COMPANY 

Address 

: 21605 Plummer Street, Chatsworth, California 91311 U.S.A. 

Telephone No. 

: (818)998-7322 

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it. 

AC Power Cord used in the United States and Canada is listed by the Underwriters Laboratories 
(UL) and certified by the Canadian Standard Association (CSA). 
AC Power Cord has a grounding-type AC line plug. This is a safety feature to be sure that the 
plug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable to 
insert the plug into the outlet, contact your electrician. 

 

 

 
This cord is already fitted with a modulized plug incorporating a fuse, the value of which is indicated on the pin face of the plug. Should 
the fuse need to be replaced, an ASTA approved BS 1362 fuse must be used of the same rating, marked thus

. If the fuse cover is 

detachable, never use the plug with the cover omitted. If a replacement fuse cover is required, ensure it is of the same color as that visi-
ble on the pin face of the plug (i.e. red or orange). Fuse covers are available from the Parts Department indicated in your User 
Instructions. If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed. The end of the flexible cord 
should be suitably prepared and the correct plug fitted. 

The Wires in this mains lead are colored in accordance with the following code: 
Green-and-yellow ············ Earth 
Blue ································· Neutral 
Brown ······························ Live 
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings identifying the terminals in 
your plug proceed as follows: 
The wire which is colored green-and-yellow must be connected to the terminal in the plug which is marked by the letter E or by the safety 
earth symbol

or colored green or green-and-yellow. 

The wire which is colored blue must be connected to the terminal which is marked with the letter N or colored black. The wire which is 
colored brown must be connected to the terminal which is marked with the letter L or colored red.