EIKI LC-SXG400L 用户指南

Connect the projector’s AC power cord into an AC

outlet. The POWER indicator lights green.

Press the ON/STAND-BY button on the top control

or the ON button on the remote control. The LAMP

indicator lights red and the cooling fans start to operate.

The preparation display appears on the screen and the

count down starts.

2
3

The preparation display will disappear
after 30 seconds.

After the countdown, the input source that was

selected the last time and the lamp control status icon

(see page 49) appear on the screen.

If the projector is locked with a PIN code, PIN code

input dialog box will appear. Enter the PIN code as

instructed below.

Selected Input Source and Lamp Control

Complete peripheral connections (with a computer,

VCR, etc.) before turning on the projector.

Lamp control status

What is PIN code?

PIN (Personal Identification Number) code is a security

code that allows the person who knows it to operate the

projector. Setting a PIN code prevents unauthorized use of

the projector.

A PIN code consists of a four-digit number. Refer to the

PIN code lock function in the Setting Menu on page

51 for

locking operation of the projector with your PIN code.

After the OK icon disappears,

you can operate the projector.

PIN Code Input Dialog Box

Turning On the Projector

Basic Operation

Enter a PIN code

CAUTION ON HANDLING PIN CODE

If you forget your PIN code, the projector

can no longer be started. Take a special care

in setting a new PIN code; write down the

number in a column on page 76 of this manual

and keep it on hand. Should the PIN code be

missing or forgotten, consult your dealer or

service center.

✔

Note:

• When the Logo select function is set to “Off,”

the logo will not be shown on the screen (p.50).

• When the “Countdown off” or “Off” is selected

in the Display function, the countdown will not

be shown on the screen (p.52).

• During the countdown period, all operations

are invalid.

• If the PIN code number is not entered within

three minutes after the PIN code dialog box

appeared, the projector will be turned off

automatically.

• The “1234” is set as the initial PIN code at the

factory.

See page 49 for the Lamp control status.

✔

Note:

• The Filter warning and Lamp replacement

icons may appear on the screen depending

on the usage state of the projector.

Use the Point ed buttons on the top control or Number

buttons on the remote control to enter a number.

Use the Point ed buttons on the top control to select a

number. Press the Point 8 button to fix the number and

move the red frame pointer to the next box. The number

changes to “✳.” Repeat this step to complete entering

a four-digit number. After entering the four-digit number,

move the pointer to “Set.” Press the SELECT button so

that you start to operate the projector.

Press the Number buttons on the remote control to enter

a number (p.15). When you complete entering a four-digit

number, the pointer moves to “Set.” Press the SELECT

button so that you can start to operate the projector.

If you fixed an incorrect number, use the Point 7 button to

move the pointer to the number you want to correct, and

then enter the correct number.
If you entered an incorrect PIN code, “PIN code” and the

number (✳✳✳✳) will turn red for a moment. Enter the

correct PIN code all over again.

When using top control

When using remote control