EIKI LC-SXG400L 用户指南

✔

This remote control emits a laser beam from the laser light window. Press the LASER button to activate the 

laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is 

pressed for more than one minute or if it is released, the laser light goes off.

The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself 

or other people. The following is the caution label for the laser beam.
CAUTION:   Use of controls, adjustments or performance of procedures other than those specified herein may 

result in hazardous radiation exposure. Never look directly into the laser light window while a laser 

is emitted, otherwise eye damage may result. 

Laser Light Window

The caution label is put on the remote control.

Signal Emission Indicator

You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the 

projected image.  

Press and hold the MENU and NO SHOW buttons for 

more than 10 seconds to activate the Pointer function. 

(The Laser pointer has switched to the Pointer function.)

Press and hold the MENU 
and NO SHOW buttons for 
more than 10 seconds.

Press the LASER button on the remote control 

pointing toward the projector. The Spotlight or Pointer 

is displayed on the screen with the LASER button 

lighting green. Then move the Spotlight or Pointer with 

the PRESENTATION POINTER button. If the LASER 

button does not light green and continues to emit a 

laser beam, try the abovementioned procedure until the 

LASER button lights green. 

To clear the Spotlight or Pointer out the screen, press 

the LASER button pointing toward the projector and see 

if the LASER button lighting is turned off.

To switch to the Laser pointer again, press and hold 

the NO SHOW and MENU buttons for more than 10 

seconds or slide the RESET/ON/ALL-OFF switch to 

“RESET” and then to “ON”.

When you reset the Pointer function, the remote control 

code will be reset, as well. 

After the Laser pointer has switched to 
the Pointer, use the LASER button as 
the Pointer function ON-OFF switch. 
Press the LASER button pointing 
toward the projector and see if it lights 
green.