EIKI LC-SXG400L 用户指南

When the projection lamp of the projector reaches its end 

of life, the Lamp replacement icon appears on the screen 

and LAMP REPLACE indicator lights yellow. Replace the 

lamp with a new one promptly. The timing when the LAMP 

REPLACE indicator should light is depending on the lamp 

mode.

Follow these steps to replace the lamp.

Replacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.

●

●

  Replacement Lamp Type No . 

  

(Service Parts No. 610 335 8093)

For continued safety, replace with a lamp of the same 

type lamp. Do not drop the lamp or touch the glass 

bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes 

before you open the Lamp cover. The inside of 

the projector can become very hot.

Turn off the projector and unplug the AC power cord. 

Let the projector cool for at least 45 minutes.

Remove the two (2) screws that secure the lamp. Lift 

the lamp out of the projector by using the handle.

Replace the lamp with a new one and secure the two 

(2) screws. Make sure that the lamp is set properly. 

Put the lamp cover back and secure it with the screw.

Remove the screw that secures the lamp cover, and 

then open the lamp cover.

Connect the AC power cord to the projector and turn 

on the projector.

See “Resetting the Lamp Counter” on the next page.

Screw

Lamp replacement icon

TURN OFF THE UV LAMP BEFORE 

OPENING THE LAMP COVER

Handle

Screws

Lamp cover