JVC DLA-M5000SCE 用户手册

下载
页码 136
58
DLA-M5000CLE (Re)/ LCT0979-002A / ENGLISH
Filter Maintenance and Light-Source Lamp 
Replacement
Cleaning and Replacing the Filter
The filters should be cleaned periodically. If they are heavily stained, do not become clean if cleaned, or are damaged, 
replace them with new filters (Parts number: LC30505); otherwise, dirt and dust may get inside, possibly causing an adverse 
effect on the screen and preventing you from enjoying clear pictures.
■ The projector has two filters installed, one on the right side and the other on the back.
1
Bring the projector into stand-by state, and turn off the MAIN POWER switch.
Put the projector into stand-by, and make sure the STAND BY indicator is lit, then tun off the MAIN POWER switch. After 
that, disconnect the power cord from the wall outlet and the projector. For detailed procedures, refer to “Turning off the 
power” (page 24).
2
Remove the filter cover screws.
Using a Phillips screwdriver, remove the six screws fixing each filter.
Two filters are used, one on the right side and the other on the back of the projector.
3
Remove the filters.
To remove the filter, pinch the center portion of the filter with your fingers and pull it toward you. 
(The filter is held by four tabs.)
There are two filters used.
Note
• If the filter is clogged with dirt, etc., the projector 
goes into an emergency mode (the EMERGENCY 
indicator blinks).
• So, clean the filter periodically. For the emergency 
mode, refer to pages 7 and 23.
(To be continued on the next page)
DLA-M5000LE&SCE Eng Re.book  Page 58  Tuesday, March 12, 2002  3:59 PM