Crestron electronic CP-X4014WN 用户手册

53

6. Network Bridge Function

6.2 Communication setup

6.3 Communication port

1)  In the COMMUNICATION TYPE menu, select NETWORK BRIDGE 

(WIRELESS or WIRED depending on the type of connection you use) for the 
CONTROL port. 

2)  Using the SERIAL SETTINGS menu, select the proper baud rate and parity 

for the CONTROL port, according to the specification of the RS-232C port of 
the connected device. 

For the NETWORK BRIDGE function, send the data from the computer to the 
projector with using the Network Bridge Port that is configured in the Port 
Settings of web browser. (

23)

3)  Using the TRANSMISSION METHOD menu, set up the proper method for the 

CONTROL port according to your use. 

• The OFF is selected for the COMMUNICATION TYPE as the default 

setting.
• Using the COMMUNICATION menu, set up the communication.  Remember 
that an unsuitable setup could cause malfunction of communication.
• When either one of the NETWORK BRIDGE settings is selected in the 
COMMUNICATION TYPE menu, RS-232C commands cannot be received from 
the CONTROL port.

• Except for 41794, 9715, 9716, 9719, 9720, 5900, 5500, 4352 

between 1024 and 65535 can be set up as the Network Bridge Port number.  
It is set to 9717 as the default setting.

NOTE

NOTE

BAUD RATE

4800bps/9600bps/19200bps/38400bps

PARITY

NONE/ODD/EVEN

Data length

8 bit (fixed)

Start bit

1 bit (fixed)

Stop bit

1 bit (fixed)

To configure the setup of the communication using NETWORK BRIDGE for 
the projector, use items in the COMMUNICATION menu. Open the menu of 
the projector and select the OPTION - SERVICE - COMMUNICATION menu. 
(

OPTION menu > SERVICE > COMMUNICATION in the Operating Guide)