Summit HL-630 OPC 用户手册

 

34

 

pages. These cartridges are designed to be recycled 
by Sharp authorized dealers. As such, replacement 
chips are available from authorized Sharp dealers, 
and now generic chips are also available. Since the 
chip shuts down the cartridge at 10,000 pages, you 
can recycle the cartridge 2-3 times with the same 
chip with out any problems. However, even if you 
just recycled the cartridge, once the page count 
reaches 10,000, you will need to replace the chip. To 
make matters even more confusing, it seems that 
non-network (Copier Only) machines do not need 
the chip installed at all! We think (but have not yet 
been able to confirm), that replacing the chip every 
cycle will prevent the machine from shutting down. 
That is an increase in cost, but that way you don’t 
have to track the usage on your customer’s machine, 
or for that matter, the type of machine they have. 
The chip is installed in the back of the connector on 
the cartridge. 
 

 
The WorkCentre Pro 16 cartridges also use a chip, 
but in this case the chip does not seem to shut the 
machine down right away. This seems to work the 
same as the Sharp AR-150; it can be recycled 2-3 
times before the chip shuts the cartridge down. 
Replacement chips for these cartridges are now 
available. These cartridges differ from the others in 
that the “Oblong Tab” on the back of the cartridge 
has it’s own unique location. In addition to the tab, 
the Waste Chamber is also different. It has a 
different shape, and is held on by one screw at the 
top, and a plastic tab on the bottom. The chip is 
installed in the back of the connector on the 
cartridge. 
 
 

 
 
 
 
 

 
These cartridges have a “Single Use Killer Chip”. 
Unlike the other chips in this series, this chip shuts 
down the cartridge after the first cycle so it will be 
necessary to replace it each time. Replacement chips 
for these cartridges are now available. These 
cartridges also differ in that the “Oblong Tab” on the 
back of the cartridge has it’s own unique location. 
The chip is installed in the back of the connector on 
the cartridge. 

Both of the above cartridges are different, and not 
interchangeable but the reset procedures are the 
same. (These procedures are the same for the XC-
800/Z-835 copier OPC cartridges).  These cartridges 
are the most popular. There are also other cartridges 
that use the same supplies, but are physically 
different. There are tabs on the top of the cartridge 
that block installation into another brand copier. 
These tabs are different for each cartridge type. 
 
If the cartridge is not a "Starter cartridge", there are 
two white gears inside the green end cap. On the 
large white gear, remove the clip ring and turn the 
gear back to the start position. (This is so the