Toshiba B-EV4 用户手册

 

EO18-33025 

(Revision Date: Mar. 27, 2009) 

3.11 Replacing the Black Mark Sensor

 

3-23 

 
8.  Replace the black mark sensor with a new one, then reassemble in the reverse order 

of removal. 

 

 

 
9.  After replacing, perform a black mark sensor calibration with the button of the printer or 

the B-EV4 Setting Tool.    Failure to do this may cause a sensor error. 
Regarding the calibration with the button of the printer, refer to the Owner’s Manual.     
Regarding the calibration with the B-EV4 Setting Tool, refer to the B-EV4 Setting Tool 
Specification posted on the Barcode Knowledge Pot. 

 

URL of Barcode Knowledge Pot   

 http://barcode.toshibatec.co.jp/Ris/products/barcode/support/en/index.php 
 
10. Also, make sure the black mark sensor performs correctly for the following points. 
 

•  When the PC connected to the printer sends sample data to the printer, printing is 

performed correctly. (Specify the black mark sensor as the media sensor.) 

 

• When the [FEED] button is pressed during the unloading of a media, the status lamp 

flashes in red.