Toshiba 3511 用户手册

e-STUDIO3511/4511 ADJUSTMENT

3 - 60

November 2003  ©  TOSHIBA TEC

0.5mm–0.3

0mm

It is mainly performed at the installation. It is also required when the RADF is dislocated for some reason

such as moving the equipment.

Perform the following adjustment by using the screw of the left and right hinge.

Perform this adjustment after “3.12.1 Adjustment of RADF position”.

Turn the exposure lamp ON during the gap check. (Test Mode: 03-267)

Adjustment standard:

Adjust the height so that the platen guide front holder touches the ADF original glass.

Adjust the height so that the gap between the platen guide rear holder and the ADF original glass

becomes 0.5 mm ± 0.3.

Adjust the height by turning the height adjusting

screw on the right hinge.

Clockwise: The height of the hinge becomes high.

Counterclockwise: The height of the hinge becomes

low.

Adjust the height by turning the height adjusting

screw on the left hinge.

Clockwise: The height of the hinge becomes high.

Counterclockwise: The height of the hinge becomes

low.

Platen guide
front holder

ADF original glass

Platen guide
rear holder